AT&T 9351 - Manual (Page 20)

Remote Access Commands
Function: Command:
Play messages in Press
#, then the appropriate mailbox
a mailbox number ( 1, 2, or 3). The system plays
new messages. If there are no new
messages, the system plays old messages.
Repeat a message Press
# 4 while message is playing;
each press backs up another message.
Skip a message Press
# 6 while message is playing;
each press advances another message.
Stop Press
# 5.
Save messages Hang up.
Delete message Press
# 9 while message is playing.
Review announcement Press
# 7; system plays announcement,
then beeps.
Record announcement Press
* 7; after beep, record
announcement, press
# 5 to stop.
System plays back announcement.
Record memo Press
* 8; then mailbox number where
you want memo recorded; speak after
beep; press
# 5 to exit.
End remote access call Press
* 0.
Turn system off Press
# 0; the system announces,
“The machine is off.” Press
# 0 again
to turn the system back on.
Turn system on When system is off, it answers after 10
rings and announces, “Please enter your
security code.”
Press
#, then enter your
remote access code.
NOTE: The remote access call will automatically end if 20 seconds go by
with no key being pressed (other than when recording or playing
messages or announcements).
ANSWERING SYSTEM OPERATION
AT TOUCH TONE PHONE
18
9351_book_2ATT 1/1/01 3:33 PM Page 18