Silver King SKRB27 User Manual

Page 2

TECHNICAL MANUAL

SILVER KING FRONT BREATHING REFRIGERATORS

MODELS SKRB27 AND SKRB27D

Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the

most reliable equipment in the industry today. Please read this manual and the accompanying warranty

information before operating your new Silver King unit. Be sure to complete and mail the warranty card

within 10 days of purchase to validate your warranty.

INSPECT FOR DAMAGE AND UNCRATE

Upon delivery of your new Silver King unit, uncrate at once to examine and test for possible damage

following the instructions printed on the exterior of the container. Report any damages to the carrier re-

sponsible for transportation and promptly present a claim for any evidence of mishandling. Save all pack-

aging materials if a claim must be filed.

INSTALLATION

The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing

and shipping. This covering can be readily stripped before installation. After removing this covering, wash

the interior and exterior surfaces using a warm, mild soapy water solution and a sponge or soft cloth. Rinse

afterward with clean water and wipe dry.

Location

When locating your new Silver King unit, convenience and accessibility are important considerations, but

the following installation guidelines must be observed;

* Always avoid locating the unit adjacent to an oven, heating element or hot air source which could ad-

versely affect the performance of the unit.

* If the unit is not on casters, it is designed to be sealed to the floor with a waterproof sealant as required by

NSF International. To do so, locate the unit in its desired location (following the installation instructions),

apply a bead of sealant around the perimeter of the unit at the base and smooth out with a finger to form a

radius with the floor and the unit.

* The unit must be level.

* For proper ventilation, the bottom front of the unit must not be obstructed.

Shelves

Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with

the tang go on the rear Pilasters. This shelf system allows for easy adjustment to suit your needs.

Drawers

To remove the Drawers on the drawer models for cleaning, simply open them fully, push the stop levers out

of the way on the Cabinet Drawer Tracks while pulling the Drawer out. To reinstall the Drawer, line up the

Drawer Tracks on the cabinet and the Drawer and push the Drawer into the cabinet. The Drawer Pan can

be removed by lifting it out with the Drawer extended.