Silver King SKDC48 - Manual (Page 2)

1
TECHNICAL MANUAL
SILVER KING DISPLAY CASE REFRIGERATORS
MODELS SKDC48, SKDC48PT AND SKDC48ST
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most
reliable equipment in the industry today. Please read this manual and the accompanying warranty information before
operating your new Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to
validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following the
instructions printed on the exterior of the container. Report any damages to the carrier responsible for transportation
and promptly present a claim for any evidence of mishandling. Save all packaging materials if a claim is to be filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping.
This covering can be readily stripped before installation. After removing this covering, wash the interior and exterior
surfaces using a warm, mild soapy water solution and a sponge or cloth, rinse with clean water and wipe dry.
Legs
The unit comes with Legs. Make sure that they are installed tight to prevent future thread wear.
Shelves
With the unit you will find two Shelves and a plastic bag containing eight Shelf Supports. To install the Shelves, start
by removing the Doors. To remove the Doors, lift up on the bottom of the Door until it clears the bottom door track,
then swing the bottom of the Door out and remove the Door from the cabinet. Repeat for both Doors. Install the Shelf
Supports on the Pilasters on the ends of the cabinet and install the Shelves. Replace the Doors on the cabinet. This
shelf system allows for easy height adjustment to suit your needs. In addition to installing the Shelves level, you have
the option of installing the Shelves at a slant to better display your merchandise. To do this simply install the rear Shelf
Supports a few notches higher on the Pilasters than the front Shelf Supports.
Doors
The Doors are removable for installation of the shelves and for easy cleaning. Follow the instructions above for
removing the Doors.
Location
When locating your new display case, convenience and accessibility are important considerations, but the following
installation guidelines must be followed;
• Always avoid placing the refrigerator adjacent to an oven, heating element or hot air source that would affect the
operation of the unit.
• When placing the unit on a counter, the structure must be able to support a minimum of 500 pounds.
• For proper ventilation the unit requires the following minimum clearances:
- 6 inches on compressor end or open in front and back if the end is blocked.
• The unit must be level or tilted backwards slightly.
• Model SKDC48 can be wall mounted. The Wall Mounting Kit is part number 10314-50.