Silver King SKMB User Manual
Page 2

1
TECHNICAL MANUAL
SILVER KING MODELS SKCTM AND SKMB MERCHANDISERS
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the
most reliable equipment in the industry today. Please read this manual and the accompanying warranty
information before operating your new Silver King unit. Be sure to complete and mail the warranty card within
10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible damage following the
instructions printed on the exterior of the container. Report any damages to the carrier responsible for trans-
portation and promptly present a claim for any evidence of mishandling.
INSTALLATION
If your Silver King unit has a stainless steel exterior it has been protected by a plastic covering during manu-
facturing and shipping. This covering can be readily stripped before installation. After removing this covering,
wash the interior and exterior surfaces using a warm, mild soapy water solution and a sponge or cloth.
Lid
For shipping purposes the Lid Assembly has been taped to the cabinet. Remove all the tape from the Lid
Assembly and install the Lid Assembly on the cabinet by holding in the hinge pins at the back of the Lid
Assembly and inserting them in the Hinge Brackets under the lighted display sign.
Light
The switch for the light is located at the back of the cabinet in the upper left corner. Should you ever need to
replace the Lamp, unplug the unit from the power supply, remove the 3 Screws that secure the Sign and
remove and replace the Lamp.
LOCATION
When locating your counter-top display merchandiser, convenience and accessibility are important consider-
ations, but the following installation guidelines must be followed;
Always avoid placing the unit next to an oven, heating element or hot air source that would affect the
operation of the unit.
For proper ventilation the unit requires a minimum of 6 inches of clear space behind the unit.
The unit must be level.
The counter must be able to support a minimum of 150 pounds.
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the
unit to power. The specifications on the data plate supersede any future discussion.