Silver King SKBB90 - Manual (Page 2)

1
TECHNICAL MANUAL
SILVER KING PREPARATION TABLES
MODELS SKBB59, SKBB69, SKBB90
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable
equipment in the industry today. Please read this manual and the accompanying warranty information before operating your new
Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following the instructions printed
on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for
any evidence of mishandling. Silver King is not responsible for any damages incurred during shipping. Save all packaging
materials if a claim is filed.
The back bar cooler was shipped on a skid. We recommend not removing the unit from the skid until it is as close as possible to the
desired end location.
INSTALLATION
The exterior surfaces of the cabinet have been protected by a plastic covering during manufacturing and shipping. This covering
can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a warm, mild
soapy water solution and a sponge or cloth, rinse with clean water and dry.
Location
When locating your new back bar refrigerator, convenience and accessibility are important considerations, but the following
installation guidelines must be followed;
• Always avoid placing the cooler adjacent to an oven, heating element or hot air source that would affect the operation of the
unit.
• For proper ventilation the cooler can be installed tight on the sides and back with the rear bumpers installed. The front must
be unobstructed.
• The unit must be level or tilted backwards slightly.
• If the unit is not on legs or casters it should be sealed to the floor with an NSF approved sealant to prevent water from getting
under the unit.
Shelves
Inside the cooler you will find Shelves and a bag containing Shelf Supports. The Shelf supports with the ‘tang’ install on the rear
pilasters. The shelf system allows for easy adjustment of shelf height to suit your needs.
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to power. The
specifications on the data plate supersede any future discussion.
The standard back bar cooler is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle, 1 Phase properly
grounded electrical receptacle. The power cord comes with a 3 prong plug for grounding purposes. Any attempt to cut off the
grounding spike or to connect to an ungrounded adapter plug will void the warranty, terminate the manufacturers responsibility and
could result in serious injury.
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an
extension cord.