Silver King SKBC95 - Manual (Page 2)

1
TECHNICAL MANUAL
SILVER KING PREPARATION TABLES
MODELS SKBC50, SKBC65, SKBC95
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable
equipment in the industry today. Please read this manual and the accompanying warranty information before operating your new
Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following the instructions printed
on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for
any evidence of mishandling. Save all packaging materials if a claim is filed.
INSTALLATION
The exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This covering can be
readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a warm, mild soapy
water solution and a sponge or cloth, rinse with clean water and dry.
Location
When locating your new bottle cooler, convenience and accessibility are important considerations, but the following installation
guidelines must be followed:
• Always avoid placing the bottle cooler adjacent to an oven, heating element or hot air source that would affect the operation
of the unit.
• For proper ventilation the bottle cooler can be installed tight on the sides and back with the rear bumpers installed.
• The top and front must be unobstructed.
• The unit must be level or tilted backwards slightly.
• If the unit is not on legs or casters it should be sealed to the floor with an NSF approved sealant to prevent water from getting
under the unit.
Dividers
The bottle cooler comes with dividers to aid in separating stock. The spacing of the dividers is adjustable to suit various needs.
The ends of the dividers fit into the mounting brackets on the front and rear of the liner. An additional hold-down bracket mounted to
the top front mounting bracket holds them in place. This bracket must be removed using a Phillips screwdriver in order to install or
adjust the spacers.
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to power. The
specifications on the data plate supersede any future discussion.
The standard refrigerator is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle, 1 Phase properly
grounded electrical receptacle. The power cord comes with a 3-prong plug for grounding purposes. Any attempt to cut off the
grounding spike or to connect to an ungrounded adapter plug will void the warranty, terminate the manufacturers responsibility and
could result in serious injury.
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an
extension cord.