Power Soak 33755 PS-225 Owner's Manual User Manual
Page 31
27
Prior to calling, please note the “Error Code” (if any) that can be identified by
observing LED #2 on the UPM and the “Status” green LED on the front of the
control panel. If there is a control logic error, LED #2 will flash with a “blinking”
pattern. The definitions for the patterns are as follows:
Please have this “Error Code” information available prior to calling Power Soak
Systems.
Please also have the systems serial number. This number is 5-6 digits long and
located on the lower corner of the wash tank closest to the controller.
Note: If the System is flashing an error code, try having the service person cycle
the breaker for the Power Soak as sometimes unstable power can cause a false
error.
“_“ symbol represents a “long” flash
“.” symbol represents a “short” flash
3 long & 1 short _ _ _ . = Liquid Level Error
3 long & 2 short _ _ _ . . = Temperature Sensor Error
3 long & 3 short _ _ _ . . . = Over-Current Error
3 long & 4 short _ _ _ . . . . = Over Temperature Error
3 long & 5 short _ _ _ . . . . . = Current Sensor Error
3 long & 6 short _ _ _ . . . . . . = Membrane Error