Power Soak 33019 PS-50 Owners Manual - Manual (Page 22)

21
Installation Guide
The installation and initial operational check of your new
system must be performed only by licensed and certified
plumbers and electricians.
Be sure to follow all applicable national and local electrical
codes when installing the electrical supply and/or a new
breaker. DO NOT connect the system using a power cord and
plug or an extension cord of any kind.
Electrical Requirements
The electrical requirements of your new system are on the serial number plate
located on the front of the wash sink, adjacent to the control panel enclosure and
inside the enclosure itself.
All
PowerSoak systems have a single point electrical connection, and a dedicated
circuit is required.