Power Soak MX-220 Owner's Manual - Manual (Page 18)

17
Authorized Service Agency Section
Hazard to untrained or unauthorized personnel.
The following procedures are provided for use only by an
authorized service agency. No facility owner, manager, employee
or other unauthorized person should attempt to perform any of these
procedures. To obtain the name of a recommended service agent in
your area, please call the Metcraft, Inc. Power Soak Service
Department at 800-444-9624.
When performing troubleshooting procedures, the authorized
service agency will need to open the Power Soak system's main
electrical enclosure.
Properly close the control panel before reconnecting the circuits.
Refer to the previous checklist under the "Facility Owner / Manager
Section" before proceeding to the following checklist items:
Pump leaks
Look For Correction
1 PUMP CASING PLUG loose or defective Tighten or replace
2 Defective PUMP SEAL Replace