Nieco JF64-BG - Manual (Page 18)

18 Nieco Corporation - Model JF64-BG
1. Pull the release pin.
2. Lift push bar and wire belt feeder bases up and
off.
3. Wash, rinse, and sanitize in the 3-compartment
sink.
DO NOT lift the feeder base by the feeder bar or
the chains. This will damage the feeder base.
REASSEMBLY: Pull the release pin and place
feeder base in position.
Push Bar Feeder Base (If equipped)
Feed End
Tools
Instructions
3-Compartment Sink
Clean: Every 4 hours
!
Scrub Pad
1. Lift and remove.
2. Wash, rinse, and sanitize in the 3-compartment
sink.
REASSEMBLY: Hang feeder housing on brackets.
Feeder Housing
Feed End
Tools
Instructions
3-Compartment Sink
Clean: Daily
Scrub Pad