Setting the end, Setting the set+go, Setting the time delay function – AEG BP7614000 User Manual
Page 15
3.
Use
or
to set minutes for DURATION.
4.
Touch
to confirm
5.
Use
or
to set hours for DURATION. After 5 seconds the appliance starts.
If you touch or
during setting hours for DURATION, the appliance goes to setting of
the END function.
6.
When the set time ends, an acoustic signal operates for two minutes.
symbol and time setting flash in the display. The appliance deactivates.
Touch any sensor field or open the oven door to stop an acoustic signal.
7.
Deactivate the appliance.
Setting the END
1.
Activate the appliance and set an oven function and temperature.
2.
Touch again and again until the display shows .
flashes in the display.
3.
Use
or
to set END (first you set minutes and then hours) and
or to
confirm.
4.
When the set time ends, an acoustic signal operates for two minutes.
symbol and time setting flash in the display. The appliance deactivates.
5.
Touch any sensor field or open the oven door to stop an acoustic signal.
6.
Deactivate the appliance.
Setting the SET+GO
To start of the appliance with necessary settings with only one touch of the sensor field,
any time later.
1.
Set an oven function (or programme) and temperature (refer to "Setting the oven
function" and "Changing the oven temperature").
2.
Set DURATION (refer to "Setting the DURATION").
3.
Touch again and again until will flash in the display.
4.
Touch
to set the SET+GO function.
The display shows and with a dot. This dot shows which clock function is activa-
ted.
5.
Touch any sensor field (apart from ON/OFF) to start the SET+GO function.
You can use SET+GO function only if DURATION is set.
Setting the Time delay function
DURATION and END can be used at the same time, if the oven is to be switched on
and off automatically later. In this case first set DURATION and then END function
(refer to "Setting the DURATION" and "Setting the END ").
When the Time delay function is activated the display shows static symbol of the oven
function, with a dot and . The dot shows which clock function is on in the Clock/
Residual heat display.
Clock functions
15