BRAVEN 710 - Manual (Page 7)

3
Note: True Wireless technology only supports one active
Bluetooth® connection to your device at the same time.
If any other Bluetooth® device (other than the paired
BRAVEN 710 speakers) is simultaneously connected
to your device, the BRAVEN 710 audio will distort. If
distortion occurs, power down all other Bluetooth®
devices in range of your phone/tablet, other than the
Braven 710. Refresh the Bluetooth® connections on your
phone/tablet by turning Bluetooth® off and then back on.
True Wireless is now reestablished.
For troubleshooting and tutorial videos, please go to
www.BRAVEN.com/TrueWireless
USING AS A BLUETOOTH ® RECEIVER
The BRAVEN 710 has the unique ability to act as a
“Bluetooth Receiver” for other home or audio speaker
systems that are not natively equipped for Bluetooth
connectivity.
Simply connect one end of a 3.5mm/aux cable to the
“AUDIO IN” port of your home or audio speaker system,
and plug the other end of the cable into the 3.5mm
“OUT” port on the BRAVEN 710 speaker. Then pair
your BRAVEN 710 speaker to your phone or tablet via
Bluetooth.
The audio will play over both the
BRAVEN 710 and your home or
audio speaker system. If you only
want the audio to play over your
other speakers (not through the
BRAVEN 710), press and hold
the BRAVEN 710 volume up (+)
and volume down (-) buttons simultaneously while the
audio is playing, until the Braven 710 audio stops.