Asus P/I-P55T2P4 - Manual (Page 21)

ASUS P/I-P55T2P4 User's Manual 15
III. INSTALLATION
3. Central Processing Unit (CPU)
The motherboard provides a 321-pin ZIF Socket 7 that is backwards
compatible with ZIF Socket 5 processors. The CPU that came with the motherboard
should have a fan attached to it to prevent overheating. If this is not the case then
purchase a fan before you turn on your system. Apply thermal jelly to the CPU top
and then install the fan onto the CPU.
WARNING: Without a fan, the CPU can overheat and cause damage to both
the CPU and the motherboard. (See page 24 "CPU Cooling Fan Connector.)
To install a CPU, first turn off your system and remove its cover. Locate the ZIF
socket and open it by first pulling the lever sideways away from the socket then
upwards to a 90-degree right angle. Insert the CPU with the correct orientation as
shown. Use the notched corner of the CPU with the white dot as your guide. The
white dot should point towards the end the of the lever. Notice that there is a blank
area where one hole is missing from that corner of the square array of pin holes and
a "1" printed on the motherboard next to that corner. Because the CPU has a corner
pin for three of the four corners, the CPU will only fit in the one orientation as
shown. The picture is for reference only; you should have a CPU fan that will cover
the face of the CPU. With the added weight of the CPU fan, no force is required to
insert the CPU. Once completely inserted, hold down on the fan and close the
socket's lever.
IMPORTANT: You must set jumpers for "CPU to BUS Frequency Ratio" and
jumpers for "BUS Frequency Selection" on page 10 depending on the CPU
that you install.
ZIF Socket 7 with Pentium Processor
Blank
Lever
Lock
White Dot
1
1
(CPU)
III. INST
ALLA
TION