beautypg.com

Viii, Only for u. k, Electrical plug information – Panasonic EY7270 User Manual

Page 14

background image

- 14 -

ONLY FOR U. K.

VIII

.

ELECTRICAL PLUG

INFORMATION

FOR YOUR SAFETY PLEASE READ

THE FOLLOWING TEXT CAREFULLY

This appliance is supplied with a moulded

three pin mains plug for your safety and

convenience.

A 3 amp fuse is fitted in this plug.

Should the fuse need to be replaced please

ensure that the replacement fuse has a

rating of 3 amp and that it is approved by

ASTA or BSI to BS136.

Check for the ASTA mark or the BSI mark

on the body of the fuse.

If the plug contains a removable fuse cover

you must ensure that it is refitted when the

fuse is replaced.

If you lose the fuse cover the plug must

not be used until a replacement cover is

obtained.

A replacement fuse cover can be purchased

from your local Panasonic Dealer.

IF THE FITTED MOULDED PLUG IS

UNSUITABLE FOR THE SOCKET OUTLET

IN YOUR HOME THEN THE FUSE SHOULD

BE REMOVED AND THE PLUG CUT OFF

AND DISPOSED OF SAFELY.

THERE IS A DANGER OF SEVERE

ELECTRICAL SHOCK IF THE CUT OFF

PLUG IS INSERTED INTO ANY 13 AMP

SOCKET.

If a new plug is to be fitted please observe

the wiring code as shown below.

If in any doubt please consult a qualified

electrician.

IMPORTANT:

The wires in this mains lead are

coloured in accordance with the

following code:

Blue: Neutral

Brown: Live

As the colours of the wire in the mains

lead of this appliance may not correspond

with the coloured markings identifying the

terminals in your plug, proceed as follows.

The wire which is coloured BLUE must be

connected to the terminal in the plug which

is marked with the letter N or coloured

BLACK.

The wire which is coloured BROWN must be

connected to the terminal in the plug which is

marked with the letter L or coloured RED.

Under no circumstances should either

of these wires be connected to the earth

terminal of the three pin plug, marked with

the letter E or the Earth Symbol .

How to replace the fuse: Open the fuse

compartment with a screwdriver and replace

the fuse and fuse cover if it is removable.

Fuse Cover

This apparatus was produced to BS800.

EY7270(EU).indb 14

2006/05/25 13:25:10