Panasonic MC-UG729 - Manual (Page 48)

- 48 -
➢ Clean agitator after every five uses
and every time the belt is replaced.
➢ Remove lower plate. See:
“Removing and Installing Lower
Plate” (page 46).
➢ Cut off any hair, thread, string,
carpet pile, and lint entangled
around agitator with a pair of
scissors.
➢ Remove agitator. See: “Replacing
Belt” (page 46).
➢ Remove any string or debris located
on the end caps, washers or agitator
shaft.
➢ Reinstall agitator and lower plate.
See: “Removing and Installing
Lower Plate” (page 44)
Cleaning Agitator
➢ When the bristles on the agitator are
worn so that they do not touch a
card held across the lower plate, the
agitator should be replaced.
➢ Remove lower plate and agitator.
➢ Clean debris from end caps.
➢ Position belt over belt pulley on the
new agitator. See: “Replacing Belt”
(page 46).
➢ Reinstall agitator (See: “Replacing
Belt,” page 46) and lower plate (page
44).
Card
Carte
Tarjeta
Replacing Agitator