Panasonic EY7880LP2S - Manual (Page 14)

- 14 -
Chisel Attachment (EY9HX402E)
(will be included with shipment
according to the destination)
CAUTION:
• The Chisel attachment is intended to
be used with Rotary hammer EY7880.
When used on another tool, it may cre-
ate a risk of injury.
• Disconnect Battery pack from tool or
place the switch in the locked off posi-
tion before attach or remove the Chis-
el attachment. Such preventive safety
measures reduce the risk of starting the
tool accidentally.
• Apply the lubricant grease on the shaft
in the Chisel attachment before use.
• The Chisel attachment creates heat. It
may become very hot and may cause
skin burns.
Do not operate the Chisel attachment
more than 30 minutes continuously.
• To reduce the risk of injury, use the Sup-
port handle on the Rotary hammer.
• Replace the Chisel attachment immedi-
ately when the Dust protect rubber cap
is broken to avoid the dust coming in-
side the attachment.
Usage:
• Use with a Chisel bit with SDS-Plus
type shank in Rotation+Hammer mode,
for Light duty chiseling (ceramic tile re-
move, scraping sealing material etc.)
1. To attach the Chisel attachment
Remove the Support handle from
the Rotary hammer. Mount the
Chisel attachment on the tool.
Make sure to eliminate a play
between the attachment and tool.
Fix the attachment firmly on the
tool using the butterfly screw.
2. Attach the Support handle on the
Chisel attachment.
3. Insert/detach the Chisel bit
Read instruction manual of the
Rotary hammer.
4. To adjust the blade angle of the
Chisel bit
Rotate the Chisel attachment to
adjust the blade angle of Chisel bit
for better setting.
Dust Collection Cup (EY9X004E)
(Available as an optional accessory)
* Drill bits of which diameter is 20 mm
above cannot be inserted through
dust collection cup.
* Do not use the tool for cutting other
than concrete, mortar and other ceram-
ic materials. If used for cutting metal
materials, the dust collection cup may
be damaged by the metal chip heat.
1. Install a drill bit.
2. Pass the drill bit through A and fix
the cup at B by matching with the
shape of the support handle.
A B
Operation
Keep the dust collection cup in close
contact with the wall surface during
operation.
Removal
Hold the base of the dust collection
cup for removal.
Base
Please remove after thoroughly get-
ting rid of the dust in the dust collec-
tion cup.