Panasonic BL-C1A - Manual (Page 4)

Operating Instructions
4
Camera Feature Locations
BL-C1A Front View
Indicator Display *1
* 1 The information below varies depending on the indicator settings (see page 96).
* 2 The indicator turns orange if the camera is not connected to the LAN.
* 3 The indicator blinks orange if the camera is not connected to the LAN.
* 4 See page 4 of the Troubleshooting on the CD-ROM.
Indicator
The indicator color shows camera status.
(See page 96)
Lens (Focus: 0.3 m [about 11 13/16 inches]—
Unlimited)
Power
on
Normal Operation* 2
Updating Firmware
Getting IP address* 3
Got IP address
Setting
Finished setting
Not on LAN Orange blinking
Orange blinking
(The camera is reset to factory default status after 1 minute.)
FACTORY DEFAULT RESET
button pressed
Orange blinking Turning off (about 5 seconds)
UPnP TM Failure Orange blinking (About a 2-second interval)
On LAN
Using
DHCP
Automatic
Setup
Internal Failure Red blinking* 4
Green
Green
Green
Green blinking
Green blinking
Orange
Orange Orange blinking Green Green blinking
Orange blinking
The status when turned on