AT&T 9210 - Manual (Page 7)

Charging the Handset Battery Pack
This battery should remain charged up to six days with the
ringer turned on and up to 12 days with the ringer off. A
fully charged battery provides an average talk time of about
six hours.
The battery pack needs charging when:
•
A new battery is installed in the handset.
• The phone beeps twice when you press
P.
• The phone light flashes slowly.
Place the handset in the base so the CHARGING light
turns on. The battery pack is typically fully charged in
eight hours.
You can keep the battery fully charged by returning the
handset to the base after each use.
If you repeatedly get a low battery indicator, even after
eight hours of charging, the battery should be replaced. Use
only Replacement battery 3301 (SKU# 91076).
CAUTION: Charge the battery provided with or
identified for use with this product only in accor-
dance with the instructions and limitations specified
in the User’s Manual, Part 1.
Replacing the Handset Battery Pack
1 Remove the battery compartment cover on the
handset by pressing on the indentation and sliding the
cover downward.
2 Lift out the old battery pack and disconnect.
3 Plug battery pack connector into handset. Place the
battery pack and wires in the compartment.
4 Replace the cover by sliding it up into place.
5 The new battery pack must be charged before
using the phone. Place the handset in the base and
allow it to charge for at least 24 hours the first charge.
The telephone might operate before that, but for best
performance, let the battery pack charge fully.
6
B A T T E R I E S
O P E R A T I N G R A N G E
This cordless telephone operates within the maximum
power allowed by the Federal Communications Commission
(FCC). Even so, this handset and base can communicate
over only a certain distance — which can vary with the
locations of the base and handset, the weather, and the
construction of your home or office. For best performance,
keep the base antenna fully upright.
If you receive a call while you are out of range, the
handset might not ring — or if it does ring, the call might
not connect when you press
P. Move closer to the
base, then press
P to answer the call.
If you move out of range during a phone
conversation, you might hear noise or interference. To
improve reception, move closer to the base.
If you move out of range without pressing
O, your
phone will be left “off the hook.” To hang up properly, walk
back into range, periodically pressing
O.