AVE VSI-PRO - Manual (Page 52)

52
VSI-Pro Firmware Download Menu
To update the VSI-Pro, load the VSI-Pro Firmware Download Utility and follow the instructions below. Then select
“UPDATE FIRMWARE” from the menu selection.
VSI-Pro Firmware Download Utility
This document describes the VSI-Pro V13.00 Release 12. The new features of this version are able to download
firmware update via the RS-232 port. The LDROM 4K boot strap loader must be burner to the uP via a conven-
tional programmer. Then the executable program is then loaded via any terminal program such as Hyper Terminal
via a PC or compatible device. All firmware files are encoded to the AVE proprietary format and decoded by the
bootstrap loader for standard program execution.
Update Firmware of VSI-Pro
You have to connect the VSI-Pro with a Serial Program Terminal such as HyperTerminal, IC etc. But advise to use
HyperTerminal.First, you have to set the baud rate HyperTerminal to 19200
See PC Windows below to verify proper HyperTerminal setup.
PROGRAMMING
Figure P5 HyperTerminal Main Menu
DOWNLOAD SETUP
UPLOAD SETUP
UPDATE FIRMWARE
EXIT