Smart Technologies SMART Table 230i - Manual (Page 22)

Locating the remote control
The remote control is located inside the cabinet behind the metal bar. Return it to the same location
when you’re finished using it.
Setting the projector for high altitudes
If you’re using your SMART Table at 5,000' to 10,000' (1,500 m to 3,000 m) above sea level, set the
projector for high altitude use. This increases the cooling efficiency of the projector’s fans.
I M P O R T A N T
Do not operate your SMART Table at altitudes higher than 10,000' (3,000 m) above sea level.
g To set the projector for high altitude use
1. Press MENU on the remote control.
The projector’s setup menu appears.
2. Press until you select Option Settings 2, and then press ENTER.
3. Press until you select High Altitude, and then press ENTER.
4. Press or to change the high altitude use setting from Off to On, and then press ENTER.
5. Press MENU to close the projector’s setup menu.
C H A P T E R 4
Using the remote control
16