Albatron Technology PX865PEC - Manual (Page 19)

Clear CMOS Jumper: JCMOS1
The “Clear CMOS” function is used when you cannot boot your system due to some CMOS
problems, such as a password is forgotten. This jumper allows you to reset the CMOS configurations,
and then reconfigure it.
The following steps explain how to reset your CMOS configurations when you
have forgotten your system password.
1. Turn off your system and disconnect the AC power cable.
2. Set JCOMS1 to OFF (2-3 Closed).
3. Wait several seconds.
4. Set JCOMS1 to ON (1-2 closed).
5. Connect the AC power cable and turn on your system.
6. Reset your new password.
15