Making the connections, Preparing the remote control – Panasonic SCAKX14EG User Manual
Page 5
5
RQ
T
961
5
ENGLISH
5
Making the connections
Conserving power
The system consumes approximately 0.3 W when it is in
standby mode. Disconnect the power supply if you do not
use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
1
Connect the speakers.
Be careful not to cross (short-
circuit) or reverse the polarity
of the speaker wires as doing
so may damage the
speakers.
2
Connect the AM loop antenna.
Stand the antenna up on its base until it clicks.
3
Connect the FM indoor antenna.
Place the antenna where reception is best.
4
Connect the AC mains lead.
Use the supplied AC mains lead with this system
only.
Do not use an AC mains lead from other equipment.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Point the remote control at the remote control sensor,
away from obstacles, at a maximum range of 7 m directly
in front of the main unit.
1
2
3
4
To household mains socket
(4
)
(4
)
B
A
Black
Red
Tape
AKX14EG.en.book Page 5 Thursday, January 5, 2012 12:50 PM