Airstream LAND YACHT MOTORHOME - Manual (Page 66)

AIRSTREAM LAND YACHT GAS
WATER PUMP
Manufacturer:
Aquatec
17422 Pullman Street
Irvine, CA 92614
Phone: 800-975-9995
Phone: 949-225-2200
Fax: 949-225-2222
Web site: www.aquatec.com
Aquajet RV Series.
This revolutionary pump employs state-of-the-art electronics to automatically control motor speed -the
pump actually adjusts its speed as you open and close water fixtures. The Aquajet RVs exclusive soft start
feature eliminates annoying rapid cycling, and its exclusive 5-valve design can deliver twice the flow and
pressure conventional RV industry pumps.
OPERATIONAL AND INSTALLATION GUIDELINES AQUAJET RV PUMP
(Partial Reprint. Please contact Aquatec for complete instructions.)
Please read these Operational and Installation Guidelines before installing or operating the AQUAJET RV
PUMP. If additional help is needed, please consult the Factory.
CAUTIONS :
A. The pump is equipped with an electrical speed controller; please insure that electrical connections
are made in accordance with these instructions.
B. The pump is equipped with a pressure sensing demand switch, which controls the maximum
operating pressure as set at the Factory. Never subject the pump to pressures above 125 PST (9.5
bars).
C. Never operate the pump in a harsh environment or hazardous atmosphere, since motor brush and
switch may cause electrical arcing.
D. Pump head materials are designed for use with water only. Do not use with petroleum products.
E. As long as there is inlet water pressure, the pump will not stop forward flow of water even if the
motor is turned off. Be sure the system has a positive means of shutting off water supply.
F. Always consider electrical shock hazards when working with and handling electrical equipment.
If uncertain, consult an Electrician. Electrical wiring should be done by a qualified electrician
only, and all local and State Electrical Codes must be followed.
Do not subject the pump to extreme high or low (freezing) temperatures while in operation. (Operating
ambient temperature range is 32º to 115º F).
The pump will only prime if all pressure is relieved from the outlet port
G-7