Panasonic NNK105WBWPG - Manual (Page 17)

7. The roller assembly and oven cavity floor
should be cleaned regularly to avoid excessive
noise. Simply wipe the bottom surface of the
oven with mild detergent and hot water then
dry with a clean cloth. The roller assembly may
be washed in mild soapy water. Cooking
vapours collect during repeated use but in no
way affects the bottom surface or roller
assembly wheels. After removing the roller
assembly from the cavity floor for cleaning, be
sure to replace it in the proper position.
8. When using the GRILL or COMBINATION
mode, some foods may inevitably splatter
grease on to the oven walls. If the oven is not
cleaned occasionally, it may start to “smoke”
during use.
9. A steam cleaner is not to be used for
cleaning.
10. This oven should only be serviced by qualified
personnel. For maintenance and repair of the
oven contact the nearest authorized dealer.
11. Failure to maintain the oven in a clean
condition could lead to deterioration of
surfaces that could affect the life of the
appliance and possibly result in a hazardous
situation.
12. Keep air vents clear at all times. Check that
no dust or other material is blocking any of
the air vents on the top, bottom or rear of the
oven. If air vents become blocked this could
cause overheating which would affect the
operation of the oven.
En-15
English
Care of Your Oven
Technical Specifications
Power Source: 230 V, 50 Hz
Power Consumption: Maximum; 2050 W
Microwave; 1100 W
Grill; 1000 W
Output: Microwave; 800 W (IEC-60705)
Grill Heater; 1000 W
Outside Dimensions: 455 (W) x 325 (D) x 260 (H) mm
Oven Cavity Dimensions: 315 (W) x 294 (D) x 184 (H) mm
Uncrated Weight: 11 kg
Specifications subject to change without notice.
1. Turn the oven off before cleaning.
2. Keep the inside of the oven, door seals and
door seal areas clean. When food splatters
or spilled liquids adhere to the oven walls,
door seals and door seal areas wipe off with
a damp cloth. Mild detergent may be used if
they get very dirty. The use of harsh
detergent or abrasive is not recommended.
DO NOT USE COMMERCIAL OVEN
CLEANERS.
3. The outside oven surface should be cleaned
with a damp cloth. To prevent damage to the
operating parts inside the oven, water should
not be allowed to seep into the ventilation
openings.
4. If the Control Panel becomes dirty, clean it
with a soft, dry cloth. Do not use harsh
detergents or abrasives on the Control Panel.
When cleaning the Control Panel leave the
oven door open to prevent the oven from
accidentally turning on. After cleaning touch
STOP/CANCEL Pad to clear display window
or turn TIMER SELECT DIAL back to ZERO
position.
5. If steam accumulates inside or around the
outside of the oven door, wipe with a soft
cloth. This may occur when the microwave
oven is operated under high humidity
conditions and in no way indicates a
malfunction of the unit.
6. It is occasionally necessary to remove the
glass tray for cleaning. Wash the tray in
warm soapy water or in a dishwasher.
This product is an equipment that fulfills the European standard for EMC disturbances (EMC =
Electromagnetic Compatibility) EN 55011. According to this standard this product is an equipment of
group 2, class B and is within required limits. Group 2 means that radio-frequency energy is intention-
ally generated in the form of electromagnetic radiation for warming up of foods. Class B means that
this product may be used in normal household areas.