Panasonic ES8249 - Manual (Page 9)

GB 9
English
Cleaning the shaver
1
2
SELECT CLEAN
DRY
CHARGE
STATUS
1 1 Insert the
appliance plug.
2 2 Plug in the adaptor.
Remove any soap or water
on the shaver if it has been
washed with hand soap or
any other detergent. •
3 3 Remove the
protective cap and
then attach the
shaver.
Turn the shaver off before
attaching.
Check that the outer foil is not
deformed or damaged when
you are attaching the shaver. •
•
4 4 Press [SELECT] to select the course.
Each time you press [SELECT], the course changes from “Clean/
Dry/Charge”
 “Clean/Dry”  “Dry/Charge”  “Dry”  “Charge”.
The courses start approximately 6 seconds after they are
selected.
The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank as the
cleaning liquid may spill causing a malfunction.
•
•
•
•
Course
1 Charge
2 Clean/Dry/
Charge
3 Clean/Dry 4 Dry/Charge 5 Dry
Course selection
indications
CLEAN
DRY
CHARGE *
CLEAN
DRY
CHARGE
CLEAN
DRY
CHARGE
CLEAN
DRY
CHARGE
CLEAN
DRY
CHARGE
Time required (guide) [In
the low temperature]
1 hour 2 hours [+0 min] 1 hour [+0 min] 2 h 40 min 1 h 40 min
Changeable course
halfway through
2345 3 2 235 234
Course completion
summary
CLEAN
DRY
CHARGE
CLEAN
DRY
CHARGE
CLEAN
DRY
CHARGE
CLEAN
DRY
CHARGE
CLEAN
DRY
CHARGE
*The lamp goes out in 6 seconds.
The indicators on the LCD panel glow when charging, and they blink when charging is completed.
