AT&T E5630 - Manual (Page 5)

Registration
3
HANDSET 2
Before using a new E560-1 handset, you must register it with the E5633 /
E5630 / E5600 base. During registration, you must enter the 15-digit ID
number of the telephone base.The Base ID is located on the bottom of
the base unit.
The handset provided with your E5600/E5630 is
automatically registered as Handset 1. Additional
handsets will be assigned numbers in the order they
are registered (HS2, HS3, or HS4). You can register a
maximum of 4 handsets.
The E5633 has 3 handsets automatically registered as
Handset 1, 2 and 3. You can register one additional
handset, which will be assigned number 4.
The E5634B has 4 handsets automatically registered
as Handsets 1,2 ,3,and 4. You cannot register any
additional handsets to the E5634B.
To add a new handset:
• Make sure your handset batteries are properly
installed and charged.
• Your handset will display “SEARCHING...”
• Press and hold the
SELECT
key until the handset
displays “ENTER BASE ID”.
• Enter the 15-digit Base ID number from the
bottom of the base unit. (E5600 or E5630 or
E5633)
• Press
SELECT
to accept the code and complete
registration.
NOTE: If an invalid base ID code is entered you will hear an error
tone and the handset will continue to display “ ENTER BASE ID ”. To
make corrections while entering the code, you can erase digits by pressing
the DELETE key.
Once a valid base ID code is entered and accepted by
the base unit, the new handset will be assigned the
next available handset number (HS2, HS3, or HS4).
You can register a maximum of four handsets per
base unit.
Handset 1
Enter base ID, then press SELECT.
ENTER BASE ID
Handset 2 Handset 3
Handset 4
91-000341-010-000-E560-1 Manual draft.qxd 2/13/1950 7:21 PM Page 5