AT&T E2125 - Manual (Page 23)

21
Answering System Operation
Day and time announcements
To set day and time
Before playing each message, the answering system
announces the day and time the message was received.
Before using the answering system, you should follow
the steps at left to set the day and time, so messages
are dated correctly.
The system uses voice prompts to guide you. Each time
you press
CHANGE
, the day, hour, minute or year
advances by one. When you hear the correct setting,
press
TIME SET
to move to the next setting.
To check day and time
You can press
TIME SET
at any time to hear the
current day and time without changing it.
NOTE: Press and hold CHANGE to advance the minute or year by 10
(the year can be set from 2000 to 2039).
NOTE: After you set the time once, it will thereafter be set automatically
with incoming Caller ID information. The time will be set automatically only if you
subscribe to Caller ID service provided by your local telephone company (see
page 5).
1.
Make sure the answering
system is on.
2. Press TIME SET
The system will announce the cur-
rent clock setting, then announce
is
“To change clock, Press TIME
SET!¨
3. Press TIME SET
4. Press CHANGE
5. Press CHANGE
Press CHANGE
until the system announces the cor-
rect hour, then press TIME SET.
until the system announces the cor-
rect minutes, then press TIME
SET
.
NOTE: You can press and
hold CHANGE to advance
the minutes in increments of ten.
until the system announces the cor-
rect day, then press TIME SET.
6.
7. Press CHANGE
until the system announces the correct
year, then press TIME SET. The
system announces the current
clock setting.
91-005743-020-000.E2125.RO.qxd 2/13/1950 7:21 PM Page 21