Audiovox PRO-900 - Manual (Page 2)

128-6846
2 of 4
KEYLESS ENTRY
1. The Lock button on the transmitter is used to lock the vehicle's doors, the Unlock button is
used to unlock the vehicle's doors. To lock or unlock the doors simply
press and release the desired function button one time. As a keyless
entry unit, for your convenience, the parking lights will flash once when
the doors are locked and twice when the door are unlocked.
REMOTE CAR FINDER
The Lock or Unlock buttons are also used to access the car finder mode.
This feature is particularly useful in a crowded parking lot where finding
your car may be difficult. To access the car finder mode, while within
range of your car, simply press and hold either the lock or unlock button
of your transmitter for three seconds. The parking lights will begin to
flash making your vehicle more visible. The lights will stop auto-
matically after 30 seconds. If you wish to turn off the car finder mode prior to the
expiration of the 30 second timer, press and release either the lock or unlock button of
your transmitter one time
.
REMOTE STARTING THE VEHICLE
The system will not start the vehicle if any one of the following situations exists;
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the Key/Option button two times within 2 seconds.
The vehicle will start and remain running for the pre-programmed 5,10,15,20 minute run
cycle. As a visual indication, the parking lights will flash or remain on depending on
the setting by your installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring
loaded start position), then step on the brake pedal to disengage the remote starter. The
vehicle will continue to run, but now on it's own power.
NOTE: The engine will stop running before the pre-programmed run cycle has expired if
you perform any one of the following functions;
-Press and release button 2 on the keychain transmitter two times within 2 seconds.
-Depress the brake pedal.
-Open the vehicle's hood
-Move the safety control switch to the Off position.
Your unit is also packaged with a two way confirming transmitter shown Right
which has Icon LED's to indicate the function and status of your vehicle.
The top LED indicates:
a) Transmit,whenever a transmitter button is operated this LED will turn on
Green.
b) Out of range, when after pressing a transmitter button, if the unit does not
receive the command, this LED will turn on Red and the transmitter will beep
twice indicating the command was not received or acted upon by the unit in
the vehicle.
c) Low Battery, if when pressing any transmitter button, this LED illuminates
Red.
2