AT&T 272 - Manual (Page 8)

6
4 Connect the line cord(s) to your modular wall jack(s) and
mount the telephone on the wall jack.
•
If you have a two-line jack, plug the free end of the short line
cord into a modular wall jack. Make sure the cord snaps firmly
into place. Place the phone on the wall jack mounting studs and
pull down until it is held securely.
• If you have two separate jacks, plug the free end of the long
line cord into the jack where you are not mounting the phone
(baseboard jack). Plug the free end of the short cord into the
jack where you are mounting the phone. Make sure the cords
snap firmly into place. Place the phone on the wall jack
mounting studs and pull down until it is held securely.
5 Follow Steps 5, 6, and 7 in “Table/Desk Installation.”
INSTALLATION