Avanti WCR5404DZD - Manual (Page 12)

12
 To remove the shelves out of the rail pull each shelf approximately 1/3 out. Use a long flat
screwdriver to press down the right plastic notch as shown in Figure A and at the same time lift
the left plastic notch as shown in Figure B. Then proceed to pull out the shelf slowly. Contact our
service department if assistance is needed.
Figure A Figure B
CARE AND MAINTENANCE
 CLEANING YOUR WINE CHILLER
 Turn off the power, unplug the appliance, and remove all items including shelves.
 Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
 Wash the shelves with a mild detergent solution.
 Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
 Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with
a clean soft cloth.
 Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur.
 POWER FAILURE
 Most power failures are corrected within a few hours and should not affect the temperature of
your appliance if you minimize the number of times the door is opened. If the power is going to be
off for a longer period of time, you need to take the proper steps to protect your contents.
 MOVING YOUR WINE CHILLER
 Remove all items.
 Securely tape down all loose items (shelves) inside your appliance.
 Turn the adjustable legs up to the base to avoid damage.
 Tape the door shut.
 Be sure the appliance stays secure in the upright position during transportation. Also protect
outside of appliance with a blanket, or similar item.
 ENERGY SAVING TIPS
 The Wine Chiller should be located in the coolest area of the room, away from heat producing
appliances, and out of the direct sunlight.