AT&T EL51209 - Manual (Page 5)

4
Telephone base & charger installation
Install the telephone as shown below. The telephone base is ready for table
use.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
www.telephones.att.com
, or call
1 (800) 222-3111
. In Canada, dial
1 (866) 288-4268
.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
1. Plug one end of
the telephone
line cord into
the telephone
jack on the
bottom of the
telephone base.
2. Plug the small
end of the AC
power adapter
into the power
jack on the
bottom of the
telephone base.
If you have DSL high speed
Internet service, a DSL filter
(not included) is required.
5. Plug the other end
of the telephone
line cord into a
telephone jack or a
DSL filter.
4. Plug the large end
of the AC power
adapter into a
power outlet not
connected to a wall
switch.
3. Route the power
adapter cord
through the slot.
Telephone line cord
Charger installation
Plug the AC power
adapter into a power
outlet not controlled
by a wall switch.