Antex electronic XM-100 - Manual (Page 23)

XM-100 Commercial Satellite Audio Receiver 23
The ―channel number‖ field selects the channel number to tune
to or one of several options. Selecting an invalid channel will
set the display to ―???‖ and the cursor will not move. Selecting
―Any‖ allows for a volume change applied to the current audio
channel at the programmed time – a feature useful for
decreasing the audio volume during slow hours of a restaurant
or bar. Locking and unlocking the front buttons for specific
hours of the day (LCK, UNL) and turning off the unit at a
specified time (Off) may also be programmed. Note that
subsequent to a programmed ―Off‖ period, any valid forced
tune event to a channel will turn the unit back ―On‖. An
existing event is deleted by choosing DEL in this field.
When finished reviewing, adding, or deleting Forced Tune
events with this menu, pressing the SEL button on the remote
will prompt to save the changes. Selecting either Yes or No will
return you to the Edit or Add New screen.
Pressing the Mode button will exit and not save any changes.
Software Version
If you press the Mode key when the menu reads ―SETUP – SW
VERSION‖, you should see a submenu similar to the following:
VER 6.30.133
Pressing the Mode key again will exit the submenu.