Sony PEG-UX50 - Manual

Sony Corporation © 2003 Printed in Japan 3-087-457-01(1)
PEG-UX50 / UX40
Notes on Picsel Viewer for CLIE and NetFront v3.0
for CLIE
If you try to display files or websites already viewed with Picsel Viewer for CLIE or
NetFront v3.0 for CLIE again, they may not be displayed properly. In this case, perform
the following:
• For files you can display on your CLIÉ handheld without connecting to the
Internet (For files you can display with Picsel Viewer for CLIE)
Disconnect from the Internet.
• For files you can display on your CLIÉ handheld by connecting to the
Internet (For files you can display with NetFront v3.0 for CLIE)
Finish the application and disconnect from the Internet. Then start the application and
connect to the Internet again.
You can configure the setting for disconnecting from the Internet automatically when
you finish NetFront v3.0 for CLIE.
How to set: While NetFront v3.0 for CLIE is opened, tap (Menu) and select
[NetFront Settings] from [Options]. In the second page, tap V next to [On termination:]
and select [Disconnect].
By default, [On termination:] is set to [Disconnect].
• Turn off your CLIÉ handheld, then turn it on again.
• Tap (Home) to display the CLIE 3D Launcher. Remove the "Memory
Stick" media from your CLIÉ handheld and then reinsert it into the
"Memory Stick" slot.
If the problem persists even after performing the above, perform a soft reset.
b For details on soft reset, refer to “Restarting your CLIÉ TM handheld: Performing a soft
reset” (page 32 ) in the supplied “Read This First (Operating Instructions)”.