AutoPage C3-RS-665 2W - Manual (Page 7)

7
exited.
Power Save Mode:
While in the power save mode, the LCD remote transceiver will “sleep” until
a button is pushed. This will extend the life of battery. When power save
mode is “ON”, the remote control will wake up periodically to check for
messages from the security module.
1. Press and hold all four remote control buttons
simultaneously unit one long beep is heard.
Programming has now been entered.
2. Within 5 seconds, press the button to toggle
“On” or “Off”. The remote will beep once for “On”,
twice for “Off”. When power save mode is “On”, the
icon on the LCD screens to indicate entry the
“power save mode”
3. To exit programming mode, take no action for five
seconds. The remote control will generate two long
beeps to indicate programming mode has been
exited.
Screen Lamp ON:
Press the
button once and the LCD screen lamp will turn on for 5
seconds.
Clear the Flash Icon and Melody Sound:
Cycle the ignition then press the
button first, within 3 seconds press
and buttons at the same time. It will clear the flash icon and melody
sound on the LCD screen transceiver.
Stop The Trigger Melody Sound: