Alpine IDA-X300 - Manual (Page 46)

44
-EN
• Secure the ground lead of the unit to a clean metal spot using a screw
(* 3 ) already attached to the vehicle’s chassis.
iPod Connection (sold separately)
USB connection (iDA-X200 only)
Connect USB cable to an iPod with iPod Dock interface cable.
Direct connection
Connect iPod direct connector to an iPod with FULL SPEED™
connection cable (KCE-422i).
Remove the iPod
Remove the iPod from FULL SPEED™ Connection Cable (or
iPod Dock interface cable (iDA-X200 only)).
• If USB is connected, after the unit has been changed to a source
other than the iPod, remove the iPod. If the iPod is removed in the
iPod mode, data may cause damage.
• If sound is not output or the iPod is not recognized even when the
iPod is connected, remove the iPod once, then connect it again, or
reset the iPod.
USB memory Connection (sold separately)
Connect USB memory
Connect USB memory to USB cable.
Remove USB memory
Pull out USB memory squarely from the USB cable.
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognized even when
USB memory is connected, remove USB memory once, then connect
it again.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
• Route the USB cable away from other cables.
Portable Audio Player Connection (sold separately,
iDA-X200 only)
Connecting a Portable audio player
Connect the cable supplied with a Portable audio player to
the USB cable.
Disconnect the Portable audio player.
Disconnect the cable supplied with the Portable audio
player from the USB cable.
• Refer also to the Owner’s Manual of the Portable audio player.
Front Frame
Screws (M5 × 8)
(Included)
Mounting Bracket
Ground Lead
This unit
* 3
iPod Dock interface Cable (Supplied, iDA-X200 only)
USB cable
FULL SPEED™
Connection Cable
(KCE-422i)
(iDA-X200 sold
separately/iDA-X300
supplied)
This unit
USB connector
USB memory
(sold separately)
Cable (iDA-X200
supplied/iDA-X300 sold
separately)
This unit
USB connector
USB memory
(sold separately)
Cable (iDA-X200 supplied/
iDA-X300 sold separately)