Sony KDE-37XS955 - Manual (Page 10)

10
(US)
Step 5:
Install the TV
WARNING
Be sure to complete the installation before connecting the
AC power cord to the wall outlet. If you allow the AC
power cord to be pinched under or between pieces of
equipment, this may result in a short circuit or an electric
shock.
Be careful not to stumble over the AC power cord or the
TV, as you may hurt yourself.
When installing a 50-inch TV on the Wall-
Mount Bracket SU-PW3M, you need to
change the position of the woofer speaker.
Changing the position of the
woofer speaker.
1 Loosen the four screws (two on each side of
the strut arms) used to secure the woofer
speaker in place about three turns.
2 Slide the woofer speaker upward completely
as shown below.
3 Retighten the four screws (loosened in step
1
) to secure the woofer speaker.
Note
If you fail to slide the woofer speaker completely in
step 2, the woofer speaker joint locating at the center
bottom of the rear side of the TV and ventilation holes
will be blocked resulting in product damage.
1
3
Remove four screws on the rear
side of the TV.
4
Attach the supplied four hooks
with the four supplied screws
(+PSW5
×
L14).
Notes
• When using an electric screwdriver, set the torque
setting to approximately 2 N·m.
• Do not place the TV face down for an extended
period as damage may occur to the front surface.
Loosen (but do not
remove) the screws.
Soft rag