Atlantic Technology SB-800 - Manual (Page 3)

3
Instruction Manual
Low Level Output
The outputs allow daisy chaining of multiple subwoofers, or as a
return path back to the processor.
Low Level Input
Use the input to connect to the subwoofer or LFE line out from
your processor/receiver.
Product Serial Number
Write this number in the space provided on page 2 for future
reference.
Voltage Select Switch
Voltage switch for use in different countries. This switch will be set
when you receive the unit. Change this setting only when you are
sure your application requires it. For US, the switch should be set
to the 115V position.
On/Off Switch
Use this switch to turn the amplifier completely on or off.
AC Input
Use the included power cord to connect your amplifier to a wall
outlet.
PHASE LEVEL INPUT OUTPUT STANDBY STATUS LOW-PASS
ON AUTO
LOW-PASS BYPASS
55 200
80
140
0 180
L / MONO
RIGHT
MIN MAX
160
AC INPUT
50-60Hz
110W MAX
FOR 110-120VAC, USE T1.0AL 250V FUSE
FOR 220-240VAC, USE T1.6AL 250V FUSE
220-240V 110-120V
ON
OFF
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
DOUBLE INSULATION - WHEN SERVICING,
USE ONLY IDENTICAL REPLACEMENT PARTS
SERIAL
MODEL
SB800BJRWWY80100
SB-800-BLK Powered Subwoofer
Bass Level Control
Use this control to set the level of bass desired
Status LED
This will be green for "on" condition, amber for "standby"
Standby Switch
When in ON position, the amplifier will always be on. When in the
AUTO position, the amplifier will be in Automatic Standby Mode.
Low-Pass Control
An adjustable (55Hz to 200Hz) @ 18dB per octave low-pass
crossover.
Phase Switch
This switch allows precise acoustic matching with satellite speaker
systems whose output may be phase reversed. Try in both posi-
tions — use the position that results in the strongest bass output.
Low-Pass Switch
When in the LOW-PASS position, adjustment of the crossover can
be made by the Crossover Control. If being fed a pre-filtered or THX
signal, place the switch at the BYPASS position.
1
4
3
2
10
8
9
SB-800 Subwoofer Rear Panel
Figure 1
1
9 11
8
7
12
5
7 2 3 4 5
6
6
11
12
10