ADT Security Services Power 864 - Manual (Page 20)

16
Recalling
Bypassed
Zones To recall the last set of bypassed zones:
1. Press , then your [access code] (if necessary).
2. Press .
3. To exit bypassing mode and return to the Ready state, press .
Bypass
Groups A Bypass Group is a selection of zones programmed into the system. If you bypass a group
of zones on a regular basis, you can program them into the Bypass Group, so that you do
not have to bypass each zone individually every time. One Bypass Group can be pro-
grammed on each partition.
To program a Bypass Group:
1. Press
, then your [access code] (if necessary).
2. Enter the two-digit numbers (01-64) of the zones to be included in the Bypass Group.
On LCD5500Z keypads, you can also use the keys to find the zone to be
included in the bypass group, and then press to select the zone.
3. To save the selected zone into the group, press .
4. To exit bypassing mode and return to the Ready state, press .
To select a Bypass Group when arming the system:
1. Press
, then your [access code] (if necessary).
2. Press . The next time the system is armed, the zones in this group will be
bypassed.
3. To exit bypassing mode and return to the Ready state, press .
NOTE: Bypass Groups are only recalled if the system is armed/disarmed after pro-
gramming the bypass group..