AstroStart RS-113 - Manual (Page 5)

5
RS-113 COMMAND CODES
Command 1 BT 2 BTS 3 BTS 4 BTS Confirmatio
n
Start/stop A A A 1A Lights
Activate Antitheft B 1B Lights
Lock B 1B Lights
Deactivate Antitheft C 1C Lights
Unlock C 1C Lights
Trunk release B&C 1B&C Lights
Sentinel mode B * A&B 1A&B Lights
Start only A&B * A&C 1A&C Lights, horn
Car finder A&B / A&C A&B / A&C Lights, horn
Controlled output A&B / A&C A&B / A&C Lights
Channels 2,3 and 4 on 4-button remote are not used on RS-113.
Confirmation of these commands can be programmed as ACTIVE or INACTIVE
during installation. When programmed as INACTIVE, there is no confirmation.
* Function “B” on 2-button remote control corresponds to command “A&B”.
* Function “A&B on 2-button remote control corresponds to command “A&C”.
Shaded areas correspond to options
that can be programmed during
installation. A maximum of two of
these commands can be selected;
see option list opposite. “Car finder”
and “Controlled output” functions
can be allocated to either of A&B or
A&C commands depending on
available options.
A&B
Sentinel
Sentinel
Sentinel
Controlled output
Controlled output
Car finder
A&C
Start only
Controlled output
Car finder
Start only
Car finder
Start only
9
Option 1 is programmed at factory. Ask your dealer if this option was changed during
installation and if so, check 9 appropriate box.
START COMMANDS
STARTING AND STOPPING YOUR ENGINE
To start your engine, enter command from table (horn: 0, lights: 1). System
automatically sets ignition contact time depending on your vehicle. Parking lights will
stay on all the time engine is running.
To stop engine, enter same command.