Using the remote control – Arcam P35 User Manual

Page 9

Using the remote control

NOTE
Remember to install the two AAA batteries supplied
before trying to use your remote control.
Do not place anything in front of the FMJ badge on
the top left of the C30 (where the IR receiver is
located), or the remote control may not work.

CR-389 Remote Control
The CR-389 remote control gives access to all functions available on
the front panel of the C30. It also has controls to operate Arcam CD
players, AM/FM tuners and DAB tuners. The remote control transmits
Philips RC-5 type codes.

DAB

PROG

DISP

RPT

MODE

BAND

1-9

2-10

3-11

DAB

SEL

TUNER

CR-389

AMPLIFIER

VCR

DVD

TAPE

TUNER

AUX

PHONO

ENTER

SP1

SP2

DISP

4-12

5-13

6-14

7-15

8-16

TUNER

These buttons are used to control tuner functions.

Note that the

FM/DAB

lights indicate into which mode you are

switching the remote control. The lights only illuminate for five

seconds to conserve battery power.

If neither light is illuminated this does

not mean that the

remote control is not working!

(UP and DOWN)

Perform the same function as the

buttons on the front

panel (see page 7).

SELECT

Performs same function as the

SELECT

button on the front

panel. It allows you to use the remote’s volume switch in the

same way you use the control dial on the front panel – to

adjust various amplifier settings (see page 7).

Note that pressing

+ corresponds to turning the

Control knob clockwise,

– to anticlockwise.

ENTER

Performs the same function as the

ENTER

button on the front

panel (see page 7).

Source selection buttons

These operate in the same way as the source selectors on the

front panel of your C30.

Power/Stand-by
Toggles the amplifier between stand-by mode and full power
mode. The power indicator light next to the power button on
the front panel is red if the amplifier is in stand-by, amber while
the amplifier is powering up (this only takes a few seconds) and
green when the amplifier is powered up.

SP1 and SP2
These buttons are for use with the P35 amplifier, to allow you
to select and deselect the main (SP1) and secondary (SP2) sets
of speakers attached to it (see page 13 for further information).

DISP (display)
Cycles through the settings ‘Off ’, ‘Dim’ and ‘Bright’. Turning the
display ‘Off ’ may give a slight improvement in sound quality.

Volume and (mute)
Press

+ to increase volume or – to decrease the output volume

of the amplifier.

Press to mute the pre-amp outputs of the C30. Note that
both tape outputs and the headphone socket will remain active.
Mute is disabled either by pressing again, or by adjusting the
volume.

You can use the remote’s volume control in conjunction with
the

SELECT

button to adjust balance, tone and amplifier settings.

CD controls
These offer basic control of Arcam CD players