Agri-Fab 45-0331 - Manual (Page 6)

6
8. (Figure 6) Assemble the height adjustment handle to
the height adjustment tube as shown in fi gure six. Use
two curved head bolts (C), bowed washers (L), 5/16"
lock washers (K) and 5/16" hex nuts (H). Do not tighten
yet.
9. (Figure 6) Assemble the grip onto the height adjustment
handle.
10. (Figure 7) Insert a 5/16" x 3/4" hex bolt (F) through the
angle bracket. Assemble onto the bolt (in order) the
spacer bushing (T), the height adjustment strap, a 5/16"
fl at washer (J) and a 5/16" hex lock nut (G). Tighten.
If your tractor hitch has 11" to 13" ground clearance re-
fer to fi gure 4. If your tractor hitch has 8" to 11" ground
clearance refer to fi gure 5.
5. (Figure 4 or 5) Assemble the hitch brackets to the hitch
tubes using two 5/16" x 2" hex bolts (B) and 5/16" hex
lock nuts (G). The bolts should straddle the front hitch
tube bolt. Do not tighten yet.
6. At this time tighten the four bolts fastening the hitch
tubes to the sweeper housing. Next, tighten the two bolts
fastening the ends of the hitch tubes together. Finally,
tighten the two bolts fastening the hitch brackets to the
hitch tubes.
7. (Figure 4 or 5) Assemble the hitch pin (Y), two 3/4"
spacers (U) and the 1/8" hair cotter pin (N) to the hitch
brackets.
4
5/16" x 2"
HEX BOLT (B)
5/16" HEX
LOCK NUT (G)
3/4" SPACER (U)
HITCH BRACKET
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (N)
HITCH PIN (Y)
CURVED
HEAD BOLT (C)
5/16" HEX NUT (H)
BOWED
WASHER (L)
5/16" LOCK
WASHER (K)
HEIGHT
ADJUSTMENT
HANDLE
GRIP
6
7
5
5/16" x 2"
HEX BOLT (B)
5/16" HEX
LOCK NUT (G)
3/4" SPACER (U)
HITCH PIN (Y)
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (N)
HITCH BRACKET
ENGLISH
5/16" HEX
LOCK NUT (G)
5/16" FLAT
WASHER (J)
HEIGHT
ADJUSTMENT
STRAP
5/16" x 3/4"
HEX BOLT (F)
SPACER
BUSHING (T)