Avery MONARCH 7411 - Manual (Page 3)

3
P r i n t i n g a C o n f i g u r a t i o n L a b e l
To print a configuration label, press the Test/Reset button on the back of the
Ethernet print server unit. The test page is best displayed using 4” wide by
6” long labels. If the label is too small,
some information may print outside the label
edges.
Note: If you are using supply that is
shorter than 6 inches long, temporarily
change your Supply Type in the printer
menu to “continuous” to print the entire test
label. After printing the test label, change
your supply type to your previous setting.
Some information may print outside the
label edges of narrow supply.
MonarchNet 2 Network Status
Wireless Connected
00-33-22-AK-35-18 MAC
CZMO –7.01L
(2006.05.23)
Nwk Ver –
7.3 Boot Ver
Ver 5.1 WiFi Ver
1.0 Prn Ver
192.0.0.192 IP Address
255.255.0.0 Subnet Mask
192.0.0.192 IP Gateway
(via DHCP 192.0.10.192)
AUTO Boot Method
3 Boot Tries
0 min Timeout
1 min Keep Alive
ABC123 WiFi SSID
INFRASTRUCTURE W iFi Mode
11 W iFi Speed
Disabled WiFi WEP
72 Signal Strength
Actual SSID
Attached AP MAC
2485 Packets Received
225990 Bytes Received
448 Bad Packets Received
0 Receiver Overruns
193 Packets Transmitted
23731 Bytes Transmitted