Ultra Start 2250M User Manual

Page 2

2250 Wiring Diagram Page 3
Pre-Installation Page 4
Components
Recommended Pre-Installation Procedures
Recommended Install Procedures
Wire Connectors Page 5
6 Pin Connector
14 Pin Connector
3 Pin Red Connector
4 Pin Blue Connector
Jumper Selections
Installation Page 6
Basic Installation - Quick start
Plugging In The Module
Auto Tach Learn
Shock Sensor Programming
Programming Page 7-11
Program Overview & System Reset
Program Menu 1 (User Settings)
Program Menu 2 (Alarm Settings)
Program Menu 3 (Starter Settings)
Program Menu 4 (Tach Settings)
Other Features And Operations Page 12
Reservation Mode
Transmitter Programming
Battery Replacement
Service Mode

System Operation Page 14-15
Relay Diagrams Page 16

If the remote starter has a failed start attempt or if a safety input is activated the Diagnostic Memory will
store up to four shutdowns in memory. This information can then be accessed to determine the source of
the shutdown.
To Enter Diagnostic Mode:

Step 1 - Turn the ignition on wait two seconds then turn off. Press the Program Button and release.
Step 2 - The system will respond with three park light flashes and the siren will chirp the
same number of times as the events in memory. ( Maximum four events, four chirps)
NOTE: If the siren does not chirp, there are no events in memory.
Step 3 - Press the Program Button once to view the last shut down code. The siren will chirp once to
confirm code one. (If the siren does not chirp, there are no codes in memory).
Step 4 - The LED’s on the antenna will flash a code corresponding to a shut down trigger. Press the
Program Button again to check the second code. The siren will chirp twice to confirm code two.
Step 5 - To Clear Diagnostic Memory. While in Diagnostic Mode press and hold the Program Button for
five seconds. The park lights will flash and the siren will chirp once.

Note: Once diagnostic memory has 4 improper shutdown events in memory, the system will not
record any further shutdown events until the system memory has been cleared.

DIAGNOSTICS

PARK LIGHTS STATUS LED DIAGNOSTIC CODE
3 Flashes Series of 3 Flashes Door Opened “M” Models
3 Slow Flashes No Flashes Attempted Start - In Service Mode
4 Slow Flashes Series of 4 Flashes Not in Reservation Mode “M” unit
5 Flashes Series of 5 Flashes Hood Pin Grounded (Open)
5 Slow Flashes Series of 5 Flashes Brake Pedal Shutdown
6 Flashes Series of 6 Flashes Ignition On During Start Attempt
6 Slow Flashes Series of 6 Flashes Hood Pin Grounded
7 Flashes Series of 7 Flashes Tach Lock-Out
8 Flashes Series of 8 Flashes 3 Start Attempts with no start

NSTALLATION

UIDE

WIRING DIAGRAM

TABLE OF CONTENTS