ATEN UE-250 - Manual (Page 2)

Overview The UE-250 USB Repeat
er Cable allows you to ext
end
the dist
ance bet
ween your comput
er and your USB
peripherals by 5 met
ers (16’).
Unlike typical cables,
the
UE-250 is an act
ive ext
ension cable.
All USB signals
transmit
ted through it
are regenerat
ed to maint
ain opt
imal
signal int
egrit
y to meet
the USB 2.
0 specif
icat
ion.
Features
M
Ext
ends the dist
ance to USB devices by 5 m (16’)
M
Embedded cust
om ASI
C regenerat
es transmit
ted USB
signals to maint
ain opt
imal signal int
egrit
y
System Requirements
M
Whist
ler;
Windows:
XP,
2000,
Me,
98 SE;
Mac OS 8.
6
or higher No
te:
Only syst
ems wit
h a USB 2.
0 driver inst
alled
can support
dat
a transf
er speeds of
up to 480
Mbps;
all ot
hers only support
speeds of
up to
12 Mbps.
M
USB 2.
0 Host
Cont
roller inst
alled on the syst
em.
No
te:
The UE-250 can be connect
ed to a USB 1.
1
Host
Cont
roller,
but
in that
case,
it
only
support
s USB 1.
1 speeds (1.
5 - 12 Mbps).
Components 1.
Built
in cable wit
h USB connect
ion to USB port
on PC
or hub
2.
LED (green) indicat
es USB link
3.
Type
A
female USB port
for connect
ion from peripheral
4.
LED (red) indicat
es overcurrent
- 2 -
- 1 -
- 3 -
NO
TE:
This equipment has been tested and found to
comply with the limits for a Class B digital device pursuant to Subpart J of Part 15 of FCC Rules. These limits are designed to prov
ide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the us
er is encouraged to try to
correct the interference by one or more of the following measures: M
Reorient or relocate the receiving antenna.
M
Increase the separat
ion bet
ween the equipment
and receiver.
M
Connect
the equipment
int
o an out
let
on a circuit
dif
ferent
from that
which the receiver is connect
ed.
M
Consult the dealer or an experienced radio/television technician for help.
1
2
4
3