Karcher DE 4002 - Manual (Page 7)

7
English
2.7 Spot nozzle
• The spot nozzle can be attached either directly to
the steam gun or via the extension tubes.
• Because the steam temperature and pressure
are at their highest immediately the steam leaves
the nozzle, the closer you hold the steam jet to
the object to be cleaned, the better the cleaning
results will be.
• The spot nozzle can be used for cleaning:
– locations that are difficult to reach, such as in
corners, joints, etc.
– curtains, radiators
– lavatories
– stainless steel
– taps and similar fittings
– coated or enamelled surfaces
– and for lifting off stains.
• Use the extension tube for locations that are
particularly difficult to reach.
• If required, the circular brush can be pushed onto
the front of the spot nozzle.
Note:The circular brush is not suitable for cleaning
sensitive surfaces.
2.8 Floor nozzle
• Depending upon the actual cleaning task, the floor
nozzle can be used with the extension tubes. You
can use this nozzle for all large washable wall
and floor surfaces. Place the floor nozzle onto
the folded large cloth, and then pull the cloth
under the retaining clips on each side.
• The best results for wiping up dirt are achieved
when you turn the cloth over, or replace it,
frequently.
• For more effective cleaning of heavily soiled
surfaces, slow down your working speed to allow
the steam more time to penetrate the grime.
• Any traces of detergents left on the floor surface
to be cleaned may form streaks. As a rule these
streaks will disappear after the steam cleaner has
been applied several times.
2. Directions for use
2.9 Hand nozzle
• Depending upon the actual cleaning task, use
the hand nozzle with the extension tubes.
• You can use the hand nozzle with the cloth for
cleaning:
– small washable surfaces
– upholstery
– sensitive surfaces.
2.10 Optional accessories
Only accessories approved by the manufacturer
may be used with this unit.
Household iron (Order no. 6.959-262)
• Connect the modular plug on the household iron
to the main unit.
Steam-ironing
– For ironing all types of fabrics the temperature
control should be set at least to the
...
stage.
In this setting the steam discharged from the
iron prevents the fabric from being overheated.
– The higher the selected temperature, the dryer
and less visible is the steam; the volume of
steam remains the same however.
– As soon as the lamp on the iron extinguishes, it
is ready for use.
– As soon as you press the switch, a solenoid
valve in the main unit opens and steam flows
out of the base of the iron. If you push the
switch forwards, steam is expelled
continuously; if you push the switch towards the
rear, shots of steam are discharged.
– Begin by directing the steam onto a piece of
cloth until water no longer comes out of the iron.
– Turn the steam volume control on the main unit
to obtain the desired amount of steam.
– You can hold the iron vertically for steaming
curtains, clothes, etc.