Karcher BR 40-10 C ADV - Manual (Page 8)

- 6
Faults
Fault Remedy
Appliance cannot be started Check if the mains plug is connected.
Socket fuse rating too low, look for proper socket.
Insufficient water quantity Check fresh water level, refill tank if necessary.
Clean the ball valve in the fresh water reservoir.
Check and ensure that the fresh water reservoir is seated properly on the appliance.
Filter in the fresh water reservoir is plugged, clean filter.
Check hoses for blockages; clean if required.
Insufficient vacuum perfor-
mance Empty the wastewater reservoir.
Check and ensure that the fresh water reservoir is seated properly on the wastewater
reservoir.
Check seals on the fresh water reservoir, clean if necessary.
Clean the seals between the appliance and the dirt water reservoir and check for tight-
ness, replace if required.
Clean the fluff filter.
Clean the vacuum lips on the vacuum bar, replace if required
Suction channel plugged, clean.
Check if the vacuum bar is plugged, remove plug if required
Insufficient cleaning result Increase brush contact pressure.
Check the brushes for wear, replace if required.
Use brush rollers suited for the type of dirt and floor covering.
Brushes do not turn Check if foreign matters block the brushes; remove foreign matter if required.
Reduce contact pressure.
Overcurrent protective switch was triggered. The overcurrent protective switch will al-
low the operation after max. one minute.
Appliance vibrates. Brush rollers are deformed because they were not unloaded by tilting the slider verti-
cally when parking the appliance; replace brush rollers.
Specifications
Power
Nominal voltage
V/Hz 120 / 60
Average power consumption W 1100
Suction engine output W 500
Brush engine output W 1700
Vacuuming
Cleaning power, air quantity
l/s 20
Cleaning power, negative pressure kPa 10
Cleaning brushes
Working width
mm 400
Brush diameter mm 96
Brush speed 1/min 650
Dimensions and weights
Theoretical surface cleaning performance
m²/h 400
Fresh/dirt water reservoir volume l 10
Length (without pushing handle) mm 520
Width (without vacuum bar) mm 470
Height (without pushing handle) mm 380
Weight (without tank contents) kg 30
Noise emission
Sound pressure level (EN 60704-1)
dB(A) 71
Machine vibrations
Vibration total value (ISO 5349)
m/s² 1,0
8 EN