Transmitter and receiver placement, Power harness and pinout – Audiovox WOS500 User Manual
Page 3
Page 3 of 12
Rev. B 3/00
Transmitter and Receiver Placement:
Figure 1
For best reception the transmitter and receiver must be aligned with the
flat-pitted faces back to back. The antenna in the receiver should face the
rear of the vehicle and the antenna in the transmitter should face the front
of the vehicle. RF signal can be picked up between the receiver and the
transmitter best by using this method.
Power Harness and Pinout:
IGNITION
+12 VOLT
GND
RED (+) WIRE
RED (+) WIRE
BLACK (-) WIRE
SHRINK WRAP
BLACK (-) WIRE
RED (+) WIRE
BLACK (-) WIRE
58.5"
(+12V Ignition)
Transmitter
Receiver
Vehicle Rear
Vehicle Front
Antenna