Karcher Промышленный пылесос NT 802 IV - Manual (Page 10)

-
3
Only 1.449-141:

Release and remove the suction head.
 Insert the cloth filter and pull it over the
edge of the container.
 Insert and lock the suction head.
– If the appliance is used to vacuum wet
dirt the paper filter bag or the cloth filter
must always be removed.
– It is recommended to use a special filter
bag (wet).
ṇ
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
 Drain off dirty water through the drain-
age hose.
 Lock parking brake.
 Hold the container at the handle and tilt
it by raising it.
 Empty the container fully.
ṇ
Warning
The cartridge filters must never be removed
during vacuuming.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– After having completed the wet vacuum
operation clean the cartridge filter, the
mechanical overflow safeguard and the
container and let dry.
– If you change immediately from wet to
dry vacuuming, then replace the wet
cartridge filters with the dry ones.
 Plug in the main plug.
 Switch on the appliance at the main
switch.
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
 Turn off the appliance.
 Pull out the mains plug.
 Empty the container.
 Vacuum and wipe the appliance inside
and outside.
 Wind the suction hose and the mains
cable and hang it over the pushing han-
dle.
 Place the appliance in a dry room and
secure it from unauthorized use.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Inserting cloth filter
Wet vacuum cleaning
Remove paper filter bag/ cloth filter
Drain off dirt water
Emptying the container fully
Operation
Turning on the Appliance
Turn off the appliance.
After each operation
Shutting down
Transport
10 EN