Karcher K 5 Premium - Manual (Page 20)

– 10
 Release the lever on the trigger gun.
Note: Release the lever of the trigger
gun; the device will switch off again.
High pressure remains in the system.
 Lock the lever on the trigger gun.
ṇ
Danger
The water jet that is emitted from the high-
pressure nozzle results in a repulsion pow-
er acting on the hand spray gun. Make sure
that you have a firm footing and are also
holding the hand spray gun and spray lance
firmly.
ṇ
Danger
High-pressure jets can be dangerous if im-
properly used. The jet may not be directed
at persons, animals, live electrical equip-
ment or at the appliance itself.
Caution
Car tyres, paint or sensitive surfaces such
as wood should not be cleaned with the dirt
blaster, as there is a risk of damage.
Caution
Risk of damage to the paintwork
When working with the washing brush, it
must be free of dirt or other particles.
Illustration

Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
 Unlock the lever on the trigger gun.
 Pull on the lever of the trigger gun; the
device will switch on.
ƽ
Danger
The use of wrong detergents or chemicals
can compromise the safety of the appli-
ance.
Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were spe-
cifically developed for your appliance. The
use of other detergents and care products
may lead to premature wear and can inval-
idate your warranty claims. Please obtain
information at your local dealer or request
information directly from KÄRCHER.
ƽ
Danger
The improper use of detergents can cause
severe injuries or toxication.
When using detergents, the material data
safety sheet issued by the detergent manu-
facturer must be adhered to, especially the
instructions regarding personal protective
equipment.
Notes regarding the detergent: The most
commonly used KÄRCHER detergents can
be purchased ready to use in their Plug 'n'
Clean detergent bottles with locking lids.
This will make the pesky refilling and filling
processes redundant.
Illustration

Remove the lid from the Plug 'n' Clean
detergent bottle and press the deter-
gent bottle into the detergent connec-
tion with the opening facing down.
Illustration

Adjust the suction volume of the deter-
gent solution by means of the dosage
regulator for detergents.
 Use spray lance with pressure regula-
tion (Vario Power).
 Turn the spray lance to "Mix" position.
Note: This will mix the detergent with
the water stream.
Optional

Fill the detergent solution in the deter-
gent tank of the foam nozzle (observe
dosage instructions on the packaging of
the detergent).
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high
pressure jet.
 Release the lever on the trigger gun.
 Lock the lever on the trigger gun.
 Insert the trigger gun in its holder.
 During longer breaks (more than 5 min-
utes), also turn the appliance off using
the "0/OFF" switch.
Operation
Working with detergent
Recommended cleaning method
Interrupting operation
20 EN