Karcher Parní žehlicí stanice SI 2-600 CB - Manual (Page 7)

English 7
When unpacking the product, make sure that no
accessories are missing and that none of the
package contents have been damaged. If you
detect any transport damages please contact
your dealer.
The packaging material can be recycled.
Please do not place the packaging into
the ordinary refuse for disposal, but ar-
range for the proper recycling.
Place the ironing table on firm even ground!
Illustration
Î Unwind the mains cable of the ironing table
and slowly move the underframe towards the
front. The ironing table unfolds and can be
locked in the desired position. Then lower the
ironing table on to the floor.
Illustration
The height of the ironing table can be adjusted in
6 phases (max. height of 100 cm) and allows you
to iron while standing and sitting.
Î To adjust the height, hold the ironing surface
with both the hands, raise the ironing table
slightly and pull up the operating lever with
one hand. (Lifting the ironing table slightly
serves as a security function against acci-
dental switch-on).
The ironing table is locked again only when
you hear it locking in.
Illustration
Î Install the flexible cable holder; you can
move it to the left or the right.
Illustration
Î Insert the power cord of the ironing table in a
wall socket.
Î Start-up the steam cleaner according to the
description.
Î Insert the power cord of the steam cleaner
into the socket at the ironing table. This will
ensure power supply to the steam cleaner.
Illustration
Î Place the iron of the steam cleaner on the
rest and clamp in the cable of the iron into the
flexible cable holder.
Ironing table and steam cleaner are now
ready for use.
Please note and follow the following instructions
to ensure safe use of the ironing table!
Notes:
Please ensure that you always follow the ironing
instructions stitched on to your clothes along with
the instructions and specifications given in the in-
structions handbook of the steam cleaner and
the iron!
The blower must always be switched on while
ironing with steam - otherwise there will be con-
dense water formation.
When you shift between ventilator functions
(blow out or suck in), there is short pause due to
change in the rotational direction of the blower.
Hence, wait for a couple of seconds before con-
tinuing.
During breaks in ironing, place the hot iron on the
heat-resistant rest; please remember to first
switch off the steam function.
Illustration
Î Turn the appliance switch to the steam suc-
tion position.
Shirts, trousers (with crease), pleated skirts, din-
ner jackets, tablecloths.
– Fixes the fabric on the table; thus acts
against formation of crease.
– Causes the steam to penetrate better into the
fibre - this reduces the time taken for ironing
and gives better ironing results.
– Ensures a dry ironing table and also helps in
drying the fabric while ironing.
Start up
Assembling the ironing table
Connect the steam generator
Ironing
Steam ironing with steam suction
Specific use of steam suction: